Skip to product information
Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
  • Training Bundle
Training Bundle

Training Bundle

£35.00 £40.00

Everything you need to start making those gains! 

A 3D printed mini hangboard with two edge sizes (20mm and 15mm) and a compact lifting pin to hang your weights. Throw me in your bag and take me to the gym or set up at home and get to work. 

Easy to clean when they get logged with chalk and small enough to fit in any bag. 

Load tested to 100kg. Your cord colour may differ from that in the product photos. 
Instructions for Use

Before using, understand the safe grip options for this product:
- Open hand (Drag): Fingers are relatively straight, knuckles are below the fingertips. This is the safest grip for beginners and puts the least strain on pulleys.
- Half Crimp: Knuckles are raised to no more than a 90-degree angle. Thumb acts as a stabiliser but does not wrap over the fingers.
- Do not use a full crimp!

Always warm up appropriately before lifting heavy weights, if there is any pain or discomfort - stop using the device immediately.

When lifting weight from the floor with a lifting pin or equivalent:
- Ensure your feet are clear of the weight in the event of a failed lift
- Line your shoulder up with the centre of the weights to prevent them swinging on lift
- Bend at the knees to allow your arm to straighten
- Ensure your grip position is secure and level
- Lift! Extend your legs to an upright position, lifting the weight off the ground
- With control, lower the weight back to the ground

Please note: this is a general guide, please consult a coach or personal trainer for more specific guidance for you. Only lift what feels comfortable to you, ego lifting will only hurt you in the long run!

Warnings and Safety

Max load 100kg.

Warning: Climbing and training are inherently dangerous. This product involves the risk of serious injury, including but not limited to finger tendon/pulley ruptures, ligament damage and muscle strains.

Assumption of Risk: By using this product, you assume all risks and responsibilities for any injury or damage that may occur.

Expert use only: This training tool is designed for climbers with established finger strength. It is not recommended for beginners or those without proper climbing conditioning.

Useage: Only use with an appropriately rated carabiner for the load being lifted. Always warm up before using product and never use a full crimp when lifting. Consider where weights may fall in the event of lift failure to avoid crushing injury.

Long term use: Always inspect the device for damage before use, including ensuring the cord and knot is in tact. Stop using immediately if device is damaged.

Maintenance: Keep clean using cold water only, keep free from chemical contact and out of direct sunlight. Do not store outside.

Over 18 use only.
Materials

What's PLA? - PLA filament is a biodegradable thermoplastic made from renewable plant sources

Sends well with