Compact Lifting Pin

Name: Compact Lifting Pin
Brand: Clover
Price: 20.0 GBP
Availability: InStock

£20.00

Like a lifting pin, only more compact!

Created from a want to be able to jam training stuff into a bag without much thought, the compact lifting pin is made from a 3D printed PLA base and a 22kN rated sling.

Slide your desired weights over the sling, add a carabiner and you're ready to go! Fit to your harness for weighted pull ups, or a mini hangboard for finger training, the world is your oyster...

Load tested to 100kg

A versitile and compact lifting pin, designed as a simple way to add or remove weight from your training!

Stack with weight and loop a carabiner through the sling:
- Attach to your harness for weighted pull ups
- Attach to a fingerboard for finger strength training
- Setup on a pulley for sub-bodyweight hangs and pull ups

Please note, due to the nature of this compact sling, stacked weight plates may shift and move during use and after lowering. Please be mindful of where your weights will land.

Max load 100kg.

Warning: Climbing and training are inherently dangerous.

Assumption of Risk: By using this product, you assume all risks and responsibilities for any injury or damage that may occur.

Useage: Only use with an appropriately rated carabiner for the load being lifted. Always warm up before using weights. Consider where weights may fall in the event of lift failure to avoid crushing injury.

Long term use: Always inspect the device for damage before use, including ensuring the sling is in tact. Stop using immediately if device is damaged.

Maintenance: Keep clean using cold water only, keep free from chemical contact and out of direct sunlight. Do not store outside.

Over 18 use only.

What's PLA? - PLA filament is a biodegradable thermoplastic made from renewable plant sources

Compact Lifting Pin

Sends well with